Knock Sensor: Installation

WARNING: This page is about a different car, the 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block.
NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Locating Knock Sensor Mounting Bolt
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector to the knock sensor.

Fig 2: Locating Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler. Refer to INTERCOOLER .
Connect the ground cable to battery.

Fig 3: Connecting Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.