FixVault
Home › Subaru › 2012 › Outback R › Repair and Diagnosis › External Pages › Different variant/trim › Section 16 (Speed Control Systems (H4SO)) › Accelerator Pedal › Inspection › Check Accelerator Pedal Sensor Area (Method With Circuit Tester)

Check Accelerator Pedal Sensor Area (Method With Circuit Tester)

WARNING: This page is about a different variant/trim than selected.
  1. Remove the glove box lid assembly, glove box lower cover, instrument panel side cover RH and glove box back panel. Refer to GLOVE BOX .
  2. Turn the ignition switch to ON. (engine OFF)
  3. Measure the voltage between ECM connector terminals.
    Fig 1: Locating Glove Box Lid Assembly
    G06648245Courtesy of SUBARU OF AMERICA, INC.

    Main sensor side

    Fig 2: Measuring Voltage Between ECM Connector Terminals (Main Sensor Side)
    G06648606Courtesy of SUBARU OF AMERICA, INC.

    Sub sensor side

    Fig 3: Measuring Voltage Between ECM Connector Terminals (Sub Sensor Side)
    G07910024Courtesy of SUBARU OF AMERICA, INC.
    Accelerator pedal sensor Accelerator pedal Terminal No. Standard
    Main Not depressed (Full closed) 23 (+) and 29 (-) 1 V
    Depressed (Full opened) 3.5 V
    Sub Not depressed (Full closed) 31 (+) and 30 (-) 1 V
    Depressed (Full opened) 3.5 V
  4. After inspection, install the related parts in the reverse order of removal.
About FixVault