FixVault
Home › Subaru › 2012 › Tribeca Limited › Repair and Diagnosis › Body & Frame › Windows › Glass/Windows/Mirrors › Windshield Glass › Removal › Using Piano Wire

Using Piano Wire

  1. Remove the front pillar trim (passenger' side) and disconnect the wiper deicer connector. (Model with wiper deicer)
  2. Remove the cowl panel. Refer to REMOVAL , Cowl Panel.
  3. Remove the molding front.
  4. Apply protective tape to the body panel side to enclose the windshield glass.
  5. Make a hole in the adhesive part using drill or knife.
  6. Pass the piano wire through the hole, and attach both the wire ends securely to pieces of wood.
    Fig 1: Removing Adhesive Part Using Piano Wire
    G05004259Courtesy of SUBARU OF AMERICA, INC.
  7. Pull the wire ends alternately to cut off the adhesive part.
    CAUTION:
    • Do not tightly pull the piano wire against the windshield glass edge.
    • Be careful not to damage interior and exterior parts.
    • When removal is made with area close to instrument panel, place a protection plate over it. Pay particular attention to the removal.
    • Do not cross piano wires. Otherwise they may be cut.
About FixVault