FixVault
Home › Subaru › 2013 › BRZ Limited, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 32 (Wireless Door Lock Control System (Service Information)) › Door Control Receiver › Installation

Door Control Receiver: Installation

WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation of door control receiver.
    1. Insert the guide.
    2. Install the door control receiver using bolts.

      Standard value:T=13N.m {133kgf.cm} {9.6ft.lbf} 

    3. Connect the connector.
      CAUTION:
      • Do not use a door control receiver that has been dropped or exposed to strong impact.
      • When a wiring harness comes close to the door control receiver, the wireless performance of smart entry & start system may decrease. So, when replacing or inspecting the door control receiver and the wiring harness, do not change the route and length of the wiring harness.
  2. Installation of package tray trim panel ASSY
    1. Hook tabs to the panel and engage the four clips to install the package tray trim panel ASSY and center stop light ASSY as a single unit.
    2. Install the 4 clips.
    3. Connect the connector.
  3. Installation of the rear window side garnish RH (Refer to INSTALLATION )
  4. Installation of rear window side garnish LH
    NOTE: Install the part in the same manner as RH side.
  5. Installation of the quarter trim lid RH (Refer to INSTALLATION )
  6. Installation of quarter trim lid SUB-ASSY LH
    NOTE: Install the part in the same manner as RH side.
  7. Installation of the quarter lower trim RH (Refer to INSTALLATION )
  8. Installation of quarter lower trim LH
    NOTE: Install the part in the same manner as RH side.
  9. Installation of trunk trim cover INN RH (Refer to INSTALLATION )
  10. Installation of the trunk trim cover INN LH
    NOTE: Install the part in the same manner as RH side.
  11. Installation of the front door opening trim weather strip RH (Refer to INSTALLATION )
  12. Installation of front door opening trim weather strip LH
    NOTE: Install the part in the same manner as RH side.
  13. Installation of the front door scuff plate RH (Refer to INSTALLATION )
  14. Installation of front door scuff plate LH
    NOTE: Install the part in the same manner as RH side.
  15. Installation of separate type rear seat cushion ASSY RH (Refer to INSTALLATION )
  16. Installation of separate type rear seat cushion ASSY LH
    NOTE: Install the part in the same manner as RH side.
About FixVault