Checking/clearing diagnostic codes
WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
- Reading diagnostic codes with the SSM4
- Connect the SSM4 to data link connector.
- Turn the ignition switch to ON.
- Select the following menu items using the SSM4.: [Each System]/[Occupant Detection]/[DTC]
NOTE: For details on the DTCs, refer to "LIST OF DIAGNOSTIC CODES ". - Clearing diagnostic codes with the SSM4
- Connect the SSM4 to data link connector.
- Turn the ignition switch to ON.
- Select the following menu items using the SSM4.: [Each System]/[Occupant Detection]/[Clear Memory]
NOTE: After repairing the airbag system and, the occupant detection system, clear the failure codes recorded in the airbag control module and the occupant detection control module. - Check mode
Refer to the trouble situation on the Check list for interview to reproduce the same situation.