Rear seat outer belt assembly: Installation

NOTE: The procedures described below are for the RH side. Perform the same procedures for the LH side.

Installation of the rear seat 3-point type belt assembly OUT RH
1. Check of the inclination angle for activating the ELR locking operation
  
  Fig 1: Checking Of Inclination Angle For Activating ELR Locking Operation
  Courtesy of SUBARU OF AMERICA, INC.
  1. Slowly move the retractor from the installation position, and check that the belt is not locked when the angle is within 12° in all directions, and that it is always locked when the angle is 27° or larger in all directions.
    CAUTION: Do not disassemble the retractor.
2. Tighten the bolt A and temporally install the retractor part of the rear seat belt assembly OUT RH.
3. Install the retractor part of the rear seat belt assembly OUT RH with the bolt B.
  Standard value: T=30N.m {306kgf.cm} {22.1ft.lbf}
  
  Bolts A, B
4. Install the floor anchor part of the rear seat belt assembly OUT RH with the bolt.
  Standard value: T=30N.m {306kgf.cm} {22.1ft.lbf}
  CAUTION:
  - Pay attention to the direction to install the floor anchor part.
  - Be careful not to allow the floor anchor part ride over the location.
  - Be careful not to twist the rear seat belt assembly OUT RH.
  Fig 2: Locating Floor Anchor Part Of Rear Seat Belt assembly OUT RH And Bolt
  Courtesy of SUBARU OF AMERICA, INC.
5. ELR locking operation check
  1. Check that the belt is locked if quickly pulled out when it is mounted on the vehicle.
Installation of the rear window side garnish RH (Refer to INSTALLATION )
Installation of the quarter trim lid RH (Refer to INSTALLATION )
Installation of the quarter lower trim RH (Refer to )
Installation of front door opening trim weather strip RH
Installation of the front door scuff plate RH (Refer to INSTALLATION )
Installation of the separate type rear seat cushion assembly