Select Lever: Assembly

Installation of swivel
1. Install the 2 washers, spacer, bushing, and swivel with a snap pin.
  
  Fig 1: Locating Snap Pin
  Courtesy of SUBARU OF AMERICA, INC.
Installation of gasket
1. Install 4 spacer plates and the gasket.
  
  Fig 2: Locating Spacer Plates
  Courtesy of SUBARU OF AMERICA, INC.
Installation of select arm bracket
1. Apply Multemp D to the spring and the rod.
2. Install the spring and the rod to the select arm bracket.
  
  Fig 3: Locating Select Arm Bracket Components
  Courtesy of SUBARU OF AMERICA, INC.
3. Apply Multemp D to the select lever COMPL and the select arm bracket.
  
  Fig 4: Locating Select Lever Components
  Courtesy of SUBARU OF AMERICA, INC.
4. Apply Multemp D to the sliding surface of the rod and install the select arm bracket to the select lever COMPL.
  
  Fig 5: Sliding Surface Of Rod
  Courtesy of SUBARU OF AMERICA, INC.
Installation of select lever COMPL
1. Set the select arm bracket together with the select lever COMPL as a single unit to the base plate.
  
  Fig 6: Installation Of Select Lever Compl
  Courtesy of SUBARU OF AMERICA, INC.
Installation of arm COMPL
1. Insert the arm COMPL to the base plate.
  
  Fig 7: Locating Arm Compl
  Courtesy of SUBARU OF AMERICA, INC.
2. Use a pin punch 3 and hammer to drive in a new pin.
  
  Fig 8: Driving In Pin Using Pin Punch And Hammer
  Courtesy of SUBARU OF AMERICA, INC.
Installation of grommet
1. Install the grommet.
  
  Fig 9: Installing Grommet
  Courtesy of SUBARU OF AMERICA, INC.
Installation of D rod
1. Install the bushing D lock.
2. Install the cushion detent lock to the D rod.
3. Apply Multemp D to the D lock spring and the D rod.
4. Install the D lock spring and the D rod.
5. Install the D lock clamp.
  
  Fig 10: Locating D Lock Clamp
  Courtesy of SUBARU OF AMERICA, INC.
Installation of solenoid unit
1. Apply Multemp D to the solenoid unit and the pin.
2. Set the solenoid unit together with the shift lock release arm as a unit to the base plate and insert the pin.
  
  Fig 11: Identifying Solenoid Unit Pin
  Courtesy of SUBARU OF AMERICA, INC.
Installation of guide plate
1. Engage the 2 claws and install the guide plate to the base plate.
  
  Fig 12: Identifying Guide Plate Claws
  Courtesy of SUBARU OF AMERICA, INC.
2. Install the shaft guide pin and a new clamp push nut.
  
  Fig 13: Locating Shaft Guide Pin And Clamp Push Nut
  Courtesy of SUBARU OF AMERICA, INC.
3. Connect the connectors No. 2 and No. 3 of the shift lock solenoid connector and the connectors No. 10 and No. 11 of the manual mode switch connector.
  
  Fig 14: Identifying Shift Lock Solenoid Connector Terminals
  Courtesy of SUBARU OF AMERICA, INC.
4. Lock the terminal of the harness connector.
  
  Fig 15: Locking Terminal Of Harness Connector
  Courtesy of SUBARU OF AMERICA, INC.
5. Engage the claw and install the connector.
  
  Fig 16: Engaging Guide Plate Connector
  Courtesy of SUBARU OF AMERICA, INC.