Clear Memory Mode: Operation

Shift the select lever to "P" range.
Using the Subaru Select Monitor, on the «Main Menu» display, select {Each System Check}.
On «Each System Check Menu» display, select {Transmission Control System}.
After transmission type information is displayed, select [OK].
On «Transmission Diagnosis» display, select {Clear Memory}.
When «Done Turn Ignition Switch OFF» is displayed, select [OK].
Turn the ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
Turn the Subaru Select Monitor to OFF.

NOTE:

If {Clear Memories 2} is executed, DTCs and learned control memory are cleared.
If {Clear Memories 2} is executed, perform learning. < Refer to LEARNING CONTROL . >