FixVault
Home › Subaru › 2013 › Outback Base, Automatic CVT Trans › Repair and Diagnosis › External Pages › Different variant/trim › Section 10 (Automatic Transaxle) › Oil Charge Pipe › Installation

Oil Charge Pipe: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil charge pipe.
    NOTE: Use new gaskets and O-rings.

    Tightening torque: 

    38 N.m (3.9 kgf-m, 28.0 ft-lb) 

    Fig 1: Identifying ATF Level Gauge And Oil Charge Pipe
    G08579272Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector to the turbine speed sensor 1.
  3. Install the front exhaust pipe. Refer to INSTALLATION .
  4. Install the under cover. Refer to INSTALLATION .
  5. Lower the vehicle.
  6. Connect the ground cable to battery.
About FixVault