FixVault
Home › Subaru › 2013 › Outback Base, Automatic CVT Trans › Repair and Diagnosis › External Pages › Different variant/trim › Section 9 (Manual Transaxle & Differential) › Transfer Driven Gear › Installation

Transfer Driven Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the bearing outer race to transfer case.
    Fig 1: Identifying Bearing Outer Race
    G08581983Courtesy of SUBARU OF AMERICA, INC.
  2. Install the transfer driven gear and center differential as a unit.
    Fig 2: Identifying Transfer Driven Gear And Center Differential
    G06652310Courtesy of SUBARU OF AMERICA, INC.
  3. Select a thrust washer. Refer to INSTALLATION .
  4. Install the selected thrust washer and bearing outer race to the extension case.
  5. Install the transfer case and the extension case assembly. Refer to INSTALLATION .
  6. Install the back-up light switch and the neutral position switch. Refer to INSTALLATION .
  7. Install the manual transmission assembly to the vehicle. Refer to INSTALLATION .
About FixVault