Demonstration Mode (Luminescent Meter Model)

The demonstration mode screen of the combination meter can be displayed according to the following procedure.

CAUTION:

While IG and ACC is off and the odo/trip meter is not displayed, perform the steps described in 1 through 6 within 10 seconds.
To avoid battery discharge, perform the operation under the following condition.
- Perform the operation while the battery is being charged.
- While performing the operation and displaying the demonstration mode, close all doors and do not operate any electrical parts.
If the battery voltage is low, the demonstration mode is not initiated.
If the "Demo. Mode Setting Screen" is not turned to on in the dealer customize mode, the demonstration mode is not initiated.
When the demonstration mode display is completed, make sure that the "Demo. Mode Setting Screen" is turned to off in the dealer customize mode. Do not deliver the vehicle to the customer with the "Demo. Mode Setting Screen" is on.
Even if the backup fuse is removed, the demonstration mode can be initiated.

Press the trip meter knob twice.
NOTE: When the trip meter knob is pressed once, the odo/trip meter is displayed.
Press the information switch five times within three seconds after the above operation 1) is performed.
Press the trip meter knob once.
Press the information switch five times.
Press the trip meter knob once.
Press the information switch five times.
The "demonstration mode" is initiated.

Each demonstration mode screen is displayed in the TFT.

CAUTION: If the procedure is not performed properly, stop the operation and wait until the odo/trip meter display disappears (for approx. 10 seconds), and then perform the procedure from 1) to 6) again after confirming that the display disappeared.

NOTE: The demonstration mode will be cancelled in the following condition.

At the completion of the "goodbye screen" display that is shown 60 minutes after the demonstration mode is initiated
When the IG switch is turned to ON
When the information switch is turned to ON for two seconds
When the battery voltage is low
When the push button ignition switch is pressed with the access key out of the passenger room (model with keyless access)
When any request switch is pressed with the access key in the passenger room (model with keyless access).
When resuming the operation after cancellation, the demonstration mode is displayed, however, for the model with keyless access, the resuming can only be accepted after approx. 1 minute.