Ignition Key Lock: Inspection
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument panel lower cover.
- Remove the lower column cover.
- Unfasten the fixing clip which secures harness, and then disconnect the harness connector of the ignition switch from body harness.
- Turn the ignition key plate to each position and check the resistance between ignition connector terminals.
Switch position Terminal No. Standard LOCK - - ACC 3 and 5 Less than 1 Ω ON 3 and 1 and 4
3 and 5Less than 1 Ω ST 3 and 2
3 and 1 and 6Less than 1 Ω - Replace the ignition switch if the inspection result is not within the standard value.