FixVault
Home › Subaru › 2013 › Outback Base, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 40 (Anti-Theft System - Security And Locks) › Impact Sensor › Installation

Impact Sensor: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from ignition switch.
  2. Close all the doors and the rear gate.
  3. Press the UNLOCK button of the keyless transmitter.
  4. Disconnect the ground cable from the battery.
  5. Install the impact sensor.
  6. Change the setting of impact sensor using Subaru Select Monitor.
About FixVault