FixVault
Home › Subaru › 2013 › Outback Base, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 40 (Anti-Theft System - Security And Locks) › Impact Sensor › Operation › Impact Sensor Setting Using SUBARU Select Monitor

Impact Sensor Setting Using SUBARU Select Monitor

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the Subaru Select Monitor to data link connector.
  2. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  3. On «System Selection Menu» display, select {Integ. unit mode}.
  4. Select {ECM customizing}.
  5. Make a impact monitor setting.
    • When installing: ON
    • When removing: OFF
  6. Make a impact monitor ON/OFF setting.
    • When installing: ON
    • When removing: OFF
  7. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
About FixVault