FixVault
Home › Subaru › 2013 › Outback Base, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 40 (Anti-Theft System - Security And Locks) › Keyless Entry Control Module › Removal

Keyless Entry Control Module: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the left rear quarter trim. < Refer to REMOVAL , Rear Quarter Trim. >
  3. Disconnect the keyless entry control module harness connector.
  4. Remove the bolt and then remove the keyless entry control module.
    Fig 1: Identifying Keyless Entry Control Module Connector
    G05957972Courtesy of SUBARU OF AMERICA, INC.
About FixVault