FixVault
Home › Subaru › 2013 › Outback Base, Standard Trans › Repair and Diagnosis › External Pages › Different variant/trim › Section 8 (Automatic Transaxle) › Parking Pawl › Removal

Parking Pawl: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from vehicle body. Refer to REMOVAL .
  2. Remove the extension case. Refer to REMOVAL .
  3. Remove the center differential carrier. Refer to REMOVAL .
  4. Remove the front vehicle speed sensor. Refer to REMOVAL .
  5. Remove the parking support actuator.
    Fig 1: Identifying Front Vehicle Speed Sensor
    G05022326Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the parking pawl, parking pawl shaft and return spring.
    Fig 2: Identifying Parking Pawl, Parking Pawl Shaft And Return Spring
    G05022327Courtesy of SUBARU OF AMERICA, INC.
About FixVault