FixVault
Home › Subaru › 2013 › Outback Base, Standard Trans › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Rear Seat Belt › Installation › Shoulder Belt Ctr Assembly (Outback Model)

Shoulder Belt Ctr Assembly (Outback Model)

CAUTION: If the hook is disconnected from the vehicle body, replace the hook with the new part to prevent the decline of the fixed force of the seat.
Fig 1: Identifying Rear Seat Cushion
G06347514Courtesy of SUBARU OF AMERICA, INC.
  1. Install the shoulder belt retractor.

    Tightening torque: 

    Rear seat belt (OUTBACK model): < Refer to  REAR SEAT BELT (OUTBACK MODEL)  , COMPONENT, General Description. > 

  2. Install the roof trim.
  3. Install the remaining parts in the reverse order of removal.
    CAUTION:
    • For installation of the stereo camera cover, refer to "INSTALLATION", "Stereo Camera Cover" in the "EyeSight" article, and observe the precautions for installation. < Refer to INSTALLATION , Stereo Camera. >
    • Do not reuse the tether clips on the upper part of the front pillar trim. Always replace with a new part.
    • Once the tether clip is removed from the pillar trim, the retention power deteriorates and the front pillar trim may come off.
    • Do not reuse the clips on the upper part of the center pillar trim. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.
    • Before installing the front pillar trim, check the condition of (white) protective unwoven cloth of curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part.
  4. After installation, check the following points.
    • The seat belt is not twisted.
    • The seat belt can be pulled out and retracted smoothly.
About FixVault