FixVault
Home › Subaru › 2013 › Outback R Limited › Repair and Diagnosis › Engine Performance › System › Engine Controls (Diagnostics) (H6DO) › Drive Cycle › Procedure › Drive Cycle H › Diagnostic procedure

Diagnostic procedure

  1. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  2. With the ignition switch ON (engine stopped), read the value in «Coolant Temp.» and «Intake Air Temp.». Refer to READ CURRENT DATA FOR ENGINE (NORMAL MODE) .
  3. If the values from step  2) satisfy the following conditions, idle the engine for one minute.

    Condition 

    |Engine coolant temperature - Intake air temperature| ≤ 5°C (9°F) 

    NOTE:
    • If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied.
    • Hold the select lever in "P" range or "N" range at idling.
About FixVault