FixVault
Home › Subaru › 2013 › Tribeca › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System - Security And Locks › Ignition Key Lock › Inspection

Ignition Key Lock: Inspection

  1. Remove the instrument panel lower cover.
  2. Remove the lower column cover.
  3. Unfasten the fixing clip which secures harness, and then disconnect the connector of the ignition switch from body harness.
  4. Turn the ignition key plate to each position and check the continuity between terminals of ignition connector.
    Fig 1: Ignition Key Terminal Layout
    G05022828Courtesy of SUBARU OF AMERICA, INC.
    Switch position Terminal No. Standard
    LOCK - -
    ACC No. 3 and No. 4 Less than 1 Ω
    ON No. 3, No. 1 and No. 4
    No. 3 and No. 6    		 Less than 1 Ω
    ST No. 3 and No. 1
    No. 3, No. 2 and No. 6    		 Less than 1 Ω

    If NG, replace the ignition switch.

About FixVault