CVT Model
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pedal assembly.CAUTION:
- Apply grease to the snap pin to prevent the operating rod from wear.
- Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin.
Tightening torque:
Brake pedal: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Install the column assembly - steering. <Ref. to INSTALLATION , Steering Column.>
- Install the panel - knee guard.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the cover assembly - instrument panel LWR driver.
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
- Check that the brake light operate properly.
- Check the brake pedal after installation. <Ref. to INSPECTION , Brake Pedal.>