FixVault
Home › Subaru › 2015 › WRX Base › Repair and Diagnosis › External Pages › Different car › Section 146 (Lighting System (Service Information)) › Rear Combination Light Assembly › Installation › Sedan Model

Sedan Model

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Replace the light assembly gasket with a new part.
  2. Install the light assembly - rear combination.
    CAUTION: Be careful not to catch the harness in between the parts.

    Tightening torque: 

    4.5 N.m (0.5 kgf-m, 3.3 ft-lb) 

  3. Install the trunk trim panel - side.
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
About FixVault