Camshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the camshaft position sensor to the chain cover, and connect the connector to the camshaft position sensor.
NOTE:
- Use new O-rings.
- Apply engine oil to O-ring.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Install the air intake duct. (RH side only) < Ref. to INSTALLATION , Air Intake Duct. >