Stop Light Switch: Installation

WARNING: This page is about a different car, the 2013 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Make sure that the switch clip (gray) is securely installed to the brake pedal bracket.

Fig 1: Identifying Brake Pedal Bracket And Switch Clip
Courtesy of SUBARU OF AMERICA, INC.
While pulling up the brake pedal, insert the stop light switch until it reaches the stopper (brown) at the brake pedal side.
NOTE:
- When the stop light switch is inserted with the brake pedal not pulled up sufficiently, interference with the stop light switch may occur during brake pedal operation.
- When the stop light switch is not pressed sufficiently, the stop light will not illuminate.
Fig 2: Identifying Stop Light Switch And Stopper
Courtesy of SUBARU OF AMERICA, INC.
Turn the stop light switch clockwise and install the switch.

Fig 3: Turning Stop Light Switch To Clockwise
Courtesy of SUBARU OF AMERICA, INC.
Pull up the brake pedal and make sure that play is 0.5 - 2 mm (0.020 - 0.079 in).
Connect the stop light switch connector.
Connect the battery ground terminal.
Check that the brake light operate properly.
NOTE: It is not necessary to check or adjust the clearance to the stop light switch because it is automatically adjusted at installation.