FixVault
Home › Subaru › 2015 › WRX Base › Repair and Diagnosis › External Pages › Different car › Section 191 (Blind Spot Detection System (Service Information)) › Radar Sensor › Installation

Radar Sensor: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radar bracket.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  2. Install the radar sensor.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  3. Install the bumper face - rear.
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  5. Perform the adjustment of the radar sensor radar axis. < Ref. to RADAR AXIS ADJUSTMENT , ADJUSTMENT, Radar Sensor. >
About FixVault