Auto Headlight Beam Leveler Control Module: Installation
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the auto headlight beam leveler CM.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the relay holder.
- Install the panel - knee guard.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the cover assembly - instrument panel LWR driver.
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
- Perform initialization and reinitialization of the auto headlight beam leveler system. <Ref. to PROCEDURE , Auto Headlight Beam Leveler System.>