Rear Wheel Toe-In

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

When adjusting, adjust it to the following value.

Toe-in: Adjustment value

3±2 mm (0.12±0.08 in)

Loosen the self-locking nut after holding the bolt head section of lateral link assembly - front.
NOTE: When loosening or tightening the adjusting bolt, hold the bolt head and turn the self-locking nut.

Fig 1: Identifying Front Lateral Link Assembly And Adjusting Bolt
Courtesy of SUBARU OF AMERICA, INC.

Turn the adjusting bolt until toe-in is within the specification.

NOTE: When the left and right wheels are adjusted for toe-in at the same time, the movement of one scale graduation changes toe-in by approx. 6.0 mm (0.24 in).

To increase toe-in.
Rotate the left side clockwise.	Rotate the right side counterclockwise.
Courtesy of SUBARU OF AMERICA, INC.	Courtesy of SUBARU OF AMERICA, INC.
To decrease toe-in.
Rotate the left side counterclockwise.	Rotate the right side clockwise.
Courtesy of SUBARU OF AMERICA, INC.	Courtesy of SUBARU OF AMERICA, INC.

Attach and tighten a new self-locking nut.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)