Transfer Reduction Driven Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the new ball bearing (large) to reduction driven gear using the ST.
ST 499277100 BUSHING 1-2 INSTALLER
NOTE:
- Use a new ball bearing.
- Install to the splines inside transfer reduction driven gear shaft.
Fig 1: Installing Ball Bearing To Reduction Driven Gear Using Bushing 1-2 Installer (ST 499277100)
Courtesy of SUBARU OF AMERICA, INC.
Install the new ball bearing (small) to reduction driven gear.
NOTE: Use a new ball bearing.

ST 499277100 BUSHING 1-2 INSTALLER

Fig 2: Installing Ball Bearing To Reduction Driven Gear Using Bushing 1-2 Installer (ST 499277100)
Courtesy of SUBARU OF AMERICA, INC.
Install the snap ring to transfer reduction driven gear.