FixVault
Home › Subaru › 2015 › XV Crosstrek Base › Repair and Diagnosis › Body & Frame › Door Locks › Security And Locks › Ignition Key Lock › Replacement

Ignition Key Lock: Replacement

CAUTION:
  • Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description.>
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC SENSOR MIDPOINT SETTING MODE " of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U).>
  1. Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note.>
    NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart battery sensor.
  2. Remove the column assembly - steering. < Ref. to REMOVAL , Steering Column.>
  3. Remove the ignition key lock.
    1. Secure the column assembly - steering in a vise.
    2. Use the reverse tap and drill to remove the set bolt and remove the ignition key lock.
      CAUTION: Do not apply any impact to the set bolt by a chisel or punch.
      Fig 1: Locating Ignition Key Lock
      G08319257Courtesy of SUBARU OF AMERICA, INC.
  4. Install the ignition key lock.
    1. Secure the ignition key lock to the column assembly - steering.
    2. Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).
About FixVault