FixVault
Home › Subaru › 2016 › BRZ Limited, Automatic Trans › Repair and Diagnosis › Brakes › Traction Control › Vehicle Stability Control (VSC) System › Vehicle Stability Control System › The Slip Indicator Light Does Not Illuminate › Inspection steps

Inspection steps

CAUTION: When the skid control ECM (brake actuator assembly) has been replaced, make sure to perform [VDC sensor midpoint setting mode]. (Refer to WORK SUPPORT  )
  1. Diagnostic code output check (CAN communication system)
    1. Check CAN communication system. (Refer to HOW TO TROUBLESHOOT )

      Result

      Result Go to
      No output A
      Output exists B

      B: To CAN communication system (How to troubleshoot) (Refer to HOW TO TROUBLESHOOT )

      A: Go to next step

  2. Combination meter assembly check
    1. Turn the ignition switch to OFF.
    2. Using SSM3, display [System Operation Check Mode] of the combination meter assembly (meter CPU). (Refer to CURRENT DATA DISPLAY & SAVE/SYSTEM OPERATION CHECK MODE )
    3. Check the combination meter assembly.

      Criteria: In response to the SSM3 operation, the slip indicator light turns ON/OFF.

      NOTE: If this page is referenced while performing troubleshooting described in the symptom table, go back to the table and go to the next step before replacing parts. (Refer to SYMPTOM TABLE  )

      NG: Replacement of combination meter assembly (Refer to COMBINATION METER ASSEMBLY )

      OK: Replacement of brake actuator assembly (Refer to REMOVAL  )

About FixVault