Inspection steps
- Reading diagnostic codes
- Connect the SSM3 to the DLC3.
- Turn the ignition switch to ON.
- Turn on the SSM3.
- Using SSM3, select the following menu items: [Inspection of BRZ]/[All System Diagnosis].
- Check DTCs for the system that have been output.
- Follow the SSM3 on-screen instructions to check the diagnosis codes. (refer to DTC TABLE
)
Result
Result Go to DTCs are not output. A P0072B or P0073 is output. B B: Check the combination meter.
A: The circuit returns to normal at this point even if a DTC is detected. Reproduce the faulty condition and perform the diagnosis again.