Inspection steps
- Clearing diagnostic code
- Clear the diagnostic code using the SSM3. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)
Next
- Clear the diagnostic code using the SSM3. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)
- DTC check
- Use the SSM3 to confirm that diagnostic code B1010 is not being output again. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)
Result
Result Go to If the diagnostic code is being output again A If the diagnostic code is not output B B: Go to "How to simulate trouble phenomenon". (Refer to PROCEDURES FOR MALFUNCTION PHENOMENON SIMULATION )
A: Replace the main body ECM (Network gateway computer) (Refer to REMOVAL )
- Use the SSM3 to confirm that diagnostic code B1010 is not being output again. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)