Floor Shift, Shift Lever Assembly: Installation

Installation of lever CP
1. Install the lever CP to the floor shift control shift lever retainer.
2. Install the stopper with the 4 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
Connection of floor shift control shaft
1. Apply Permalub ECN-9 or equivalent to the tip of the floor shift control shaft.
  
  Fig 1: Locating Floor Shift Control Shaft Lubrication Application Areas
  Courtesy of SUBARU OF AMERICA, INC.
2. Temporarily install a new shift & select lever boot.
3. Connect the tip of the floor shift control shaft to the lever CP and install the plate washer and the clip, then install the shift & select lever boot.
Reverse check adjustment (refer to ADJUSTMENT )
Installation of shift lever boot
1. Install the plate CP and the shift lever boot with the 4 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
  
  Fig 2: Installing Shift Lever Boot
  Courtesy of SUBARU OF AMERICA, INC.
  
  CAUTION: Cover the lever CP with the shift lever boot, and install the inner sealing portion to the bottom of the stopper and the upper sealing portion to the groove on the bottom of the slider.
2. Connect the harness.
3. Install the insulator with the 2 clips.
Installation of console box (refer to DISASSEMBLY )