Check Radio Frequency Range Switch-Over

Model with 6.2 inch display 

1. Turn the ignition switch to ACC.
2. Press the button (a) to display the Audio OFF screen.
3. Touch the screen in order from (b) to (e).
   Fig 1: Pressing Button To Display Audio OFF Screen

   Courtesy of SUBARU OF AMERICA, INC.
   NOTE: Pressing the button (a) or turning the ignition switch from the OFF to ACC position can exit the Line Diag mode.
4. {Line Diag} screen is displayed.
   Fig 2: Screen Display - Line Diag

   Courtesy of SUBARU OF AMERICA, INC.
5. Touch {Dealer Diag} on the {Line Diag} screen.
6. The {Dealer Diag} screen is displayed.
   Fig 3: Display - Dealer Diag Screen

   Courtesy of SUBARU OF AMERICA, INC.
7. Touch the {9kHz} or {10kHz} key to switch the AM radio frequency range.

   Display key	Frequency range
   9kHz	Set the AM frequency range to 531 - 1629 kHz.
   10kHz	Set the AM frequency range to 530 - 1710 kHz.

   NOTE:

   • When the setting is changed, reboot confirmation for frequency switch-over is displayed. Select {OK} to reboot. When {cancel} is pressed, the {Dealer Diag} screen is displayed.
   • The initial settings is at 9 kHz.

Model with 7 inch display 

Operation is the same as that of navigation assembly, therefore, refer to "Navigation System". < Ref. to CHECK SPEAKER OUTPUT WITH LINE DIAG MODE , OPERATION, Navigation System. >