FixVault
Home › Subaru › 2016 › Crosstrek Base › Repair and Diagnosis › External Pages › Different car › Section 33 (Security And Locks) › Security System › Inspection › Check Security System Condition Memory

Check Security System Condition Memory

WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek and 2015 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull out the key from the ignition switch, or turn the ignition to OFF.
  2. Close all the doors, trunk lid or rear gate.
  3. Open the front hood.
  4. Press the LOCK button of the keyless transmitter or access key.
    NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals. If the 30 second monitoring lag has been set, wait for 30 seconds.
  5. Disconnect the ground cable from battery. < Ref. to BATTERY , NOTE, Note.>
    NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart battery sensor.
  6. Connect the ground cable to battery. < Ref. to BATTERY , NOTE, Note.>
  7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.
About FixVault