Auto Headlight Beam Leveler Control Module: Removal

WARNING: This page is about a different car, the 2016 Subaru Impreza and 2016 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >

Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Note. >
NOTE: For the 12 volt engine restart battery of HEV model, disconnect the ground terminal from 12V engine restart battery sensor.
Remove the cover assembly instrument panel LWR driver. < Ref. to REMOVAL , Instrument Panel Lower Cover. >
Remove the knee airbag module. < Ref. to REMOVAL , Knee Airbag Module. >
Release the lock and remove the fuse holder.

Fig 1: Locating Fuse Holder
Courtesy of SUBARU OF AMERICA, INC.
Remove the relay & fuse box.
1. Disconnect the connector.
2. Remove the bolts and nuts, and remove the relay & fuse box.
  
  Fig 2: Locating Relay And Fuse Box Bolt/Nuts
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector of body integrated unit.
NOTE: For model with keyless access with push button start, disconnect the keyless access CONTROL MODULE connector.

Fig 3: Locating Body Integrated Unit Connectors
Courtesy of SUBARU OF AMERICA, INC.
Remove the auto headlight beam leveler CONTROL MODULE.
1. Disconnect the connector.
2. Release the claws and pull out the auto headlight beam leveler CONTROL MODULE.
  
  Fig 4: Removing Auto Headlight Beam Leveler CONTROL MODULE
  Courtesy of SUBARU OF AMERICA, INC.