FixVault
Home › Subaru › 2016 › Forester 2.0XT Touring › Repair and Diagnosis › Body & Frame › Door Locks › Security And Locks › Ignition Key Lock › Replacement

Ignition Key Lock: Replacement

CAUTION:
  • Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM > General Description > CAUTION .
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > -- > VDC SENSOR MIDPOINT SETTING MODE .
  1. Disconnect the ground cable from battery.
  2. Remove the column assembly - steering. Ref. to POWER ASSISTED SYSTEM (POWER STEERING) > Steering Column > -- > REMOVAL .
  3. Remove the ignition key lock.
    1. Secure the column assembly - steering in a vise.
    2. Use the reverse tap or drill to remove the set bolt and remove the ignition key lock.
    Fig 1: Locating Ignition Key Lock Set Bolt
    G08319257Courtesy of SUBARU OF AMERICA, INC.
  4. Install the ignition key lock.
    1. Secure the ignition key lock to the column assembly - steering.
    2. Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).
About FixVault