Operating Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
NOTE:
- Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinder .
  Grease:
  
  NICHIMOLY N-130 or equivalent
- Be sure to install the clutch hose with the mark side facing upward .
- Be careful not to twist the clutch hose during installation .
- Use a new gasket .
  Tightening torque:
  
  T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
  
  T2: 37 N.m (3.8 kgf-m, 27.3 ft-lb)
Fig 1: Identifying Clutch Hose Bolts With Torque Specifications
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying Clutch Hose Bolts
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Air intake boot

3 N.m (0.3 kgf-m, 2.2 ft-lb)
After bleeding air from the operating cylinder, ensure that the clutch operates properly. Ref. to CLUTCH SYSTEM > CLUTCH FLUID AIR BLEEDING .