FixVault
Home › Subaru › 2016 › Forester 2.0XT Touring › Repair and Diagnosis › Transmission › Automatic Trans › Continuously Variable Transmission (Diagnostics) › Learning Control › Procedure › Simple Learning

Simple Learning

NOTE: Simple learning is performed with the vehicle lifted, without actually running the vehicle.
CAUTION: Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.
  1. On [Transmission Diagnosis] display of Subaru Select Monitor, Select [Work Support].
  2. On [Work Support] display of Subaru Select Monitor, select [Compulsory learning mode].
  3. Follow the messages displayed on the Subaru Select Monitor screen when working.
    NOTE: During AT learning in progress, AT OIL TEMP light in the combination meter starts flashing at 2 Hz and the learning operation starts. When the AT OIL TEMP light which was flashing at 2 Hz goes off, the following message is displayed on the screen.
  4. When [AT learning normally ended.] is displayed, simple AT learning is completed.
NOTE:
  • If communication error occurs during learning, retry the "AT learning mode" from the beginning.
  • If the message [Execute AT learning again after fixing troubles of the vehicle] is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
  • When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition switch to OFF before operating the select lever.
  • If the message [AT learning ended abnormally.] is displayed, start the "AT learning mode" over from the beginning.
    Message Main causes for abnormal termination
    [AT learning ended abnormally.]
    • A malfunction was detected during AT learning
    • The accelerator pedal was pressed during AT learning
    • An unspecified operation was performed during AT learning
    • ATF temperature became out of allowable range during AT learning.
    • Battery voltage is low.
    • The malfunction indicator light is lit.
    • Parking brake not applied strongly enough.
    • Brake pedal is not depressed fully.
    • Abnormal idle speed increase, etc.
  • For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
About FixVault