System Operation Check Mode: Operation

CAUTION:

Make sure that the system operation check mode is performed when the engine is not running.
After executing the system operation check mode, execute the Clear Memory Mode.

On [Main Menu] display, select [Each System Check].
On [System Selection Menu] display, select [Transmission Control System].
On [Transmission Control System] display, select [Work Support].
On [Work Support] display, select [System Operation Check Mode].
NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".

Item	Subaru Select Monitor display	Execution condition
Activating the actuator ON/OFF	F&R clutch solenoid	When all of the following conditions are met: P range Ignition switch is ON (engine stops) Battery voltage 10.9 V or more
	Secondary solenoid
	Primary DOWN solenoid
	Primary UP solenoid
	AWD solenoid
	Lock-up duty solenoid
	Lock-up ON/OFF solenoid