FixVault
Home › Subaru › 2016 › Outback 2.5i › Repair and Diagnosis › Body & Frame › Seats › Seat System - Seats › Power Seat System › Inspection › No Interlock With Smart Keyless

No Interlock With Smart Keyless

DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK DTC. 
Read the DTC of body integrated unit using Subaru Select Monitor.		 Is a DTC detected? Perform a check according to the DTC. Go to step 2  .
2 CHECK POWER SEAT CONTROL MODULE. 
  1. Turn the ignition switch to ON.
  2. Check «Keyless Access Key Information» on «Data monitor» of the power seat control module using Subaru Select Monitor.
  3. Check the status of key No. shown in «Keyless Access Key Information» using «Keyless Access & Start Link * Memorized».
    NOTE: Perform the inspection after an item is selected in the data select display.
 Is "Yes" displayed for the status of registered key No.? Go to step 3  . If "No" displayed, register the keyless access key again.
3 CHECK MEMORY FUNCTIONS. 
Perform the memory operation of the seat position, and check the memory replay operation.		 Does the seat position memory replay correctly? Function is normal. It is considered that the memory was cleared because the voltage falls below the operation-ensured voltage temporarily during memory restoration or manual operation. It operates normally by registering a memory. Perform the check item for "UNABLE TO PERFORM THE RELOADING OPERATION (DRIVER'S SEAT WITH MEMORY)".
About FixVault