FixVault
Home › Subaru › 2016 › WRX Base › Repair and Diagnosis (Single Page) › Accessories & Equipment › Exterior Lights › Lighting System › Auto Headlight Beam Leveler Control Module › Removal

Auto Headlight Beam Leveler Control Module: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >
  1. Disconnect the battery ground cable and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Note. >
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  2. Remove the cover assembly - instrument panel LWR driver. < Ref. to REMOVAL , Instrument Panel Lower Cover. >
  3. Remove the knee airbag module. < Ref. to REMOVAL , Knee Airbag Module. >
  4. Release the lock and remove the fuse holder.
    Fig 1: Locating Auto Headlight Beam Leveler Control Module
    G08315475Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the relay & fuse box.
    1. Disconnect the connector.
    2. Remove the bolts and nuts, and remove the relay & fuse box.
      Fig 2: Locating Relay & Fuse Box Bolts And Nuts
      G08315115Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector of body integrated unit.
    Fig 3: Identifying Body Integrated Unit Connector
    G08315116Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the auto headlight beam leveler CM.
    1. Disconnect the connector.
    2. Release the claws and pull out the auto headlight beam leveler CM.
      Fig 4: Removing Auto Headlight Beam Leveler CM
      G08315117Courtesy of SUBARU OF AMERICA, INC.
About FixVault