Demonstration Mode

The demonstration mode screen of the combination meter can be displayed according to the following procedure.

CAUTION:

While the ignition switch is OFF (ACC OFF) and the odo/trip meter is not displayed, perform the steps described in 1) through 6) within 10 seconds.
To avoid battery discharge, perform the operation under the following condition.
- Perform the operation while the battery is being charged.
- While performing the operation and displaying the demonstration mode, close all doors and do not operate any electrical parts.
If the battery voltage is low, the demonstration mode is not initiated.
To display the demonstration mode, set the "Demonstration mode permission/fault permission" of the user customize mode to "permission". For operation procedures, refer to "Application help".
When the demonstration mode display is completed, make sure to set "Demonstration mode permission/fault permission" of the user customize mode to "fault permission". Do not deliver the vehicle to the customer with "Demonstration mode permission/fault permission" set to "permission".
Even if the backup fuse is removed, the demonstration mode can be initiated.
Perform the steps described in (1) through (4) within 10 seconds.
If the procedure is not performed properly, stop the operation and wait until the odo/trip meter display disappears (for approx. 10 seconds), and then perform the procedure from (1) to (4) again after confirming that the display disappeared.

(1)	Press the trip meter knob twice. NOTE: When the trip meter knob is pressed once, the odo/trip meter is displayed.
(2)	Press the MID (i/SET) switch three times within three seconds after the operation 1) above is performed.
(3)	Press the trip meter knob once, and press the MID (i/SET) switch three times.
(4)	Press the trip meter knob once, and press the MID (i/SET) switch three times.
(5)	The "demonstration mode" is initiated.

NOTE: The demonstration mode will be cancelled in the following condition.
When resuming the operation after cancellation, the demonstration mode is displayed. However, the resuming can only be accepted after approx. 1 minute.

At the completion of the "goodbye screen" display that is shown 60 minutes after the demonstration mode is initiated
When the ignition switch is turned to ON
When the MID (i/SET) switch is turned to ON for two seconds
When the battery voltage is low
When the push button ignition switch is pressed with the access key out of the passenger room (model with keyless access with push button start)
When any request switch is pressed with the access key in the passenger room (model with keyless access with push button start)