DTC P2270 O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2: Wiring Diagram

Engine Electrical System ENGINE TYPE FA (WITHOUT PUSH BUTTON START) Ref. to the appropriate SYSTEM WIRING diagram article. ENGINE TYPE FA (WITHOUT PUSH BUTTON START).
Engine Electrical System ENGINE TYPE FA (WITH PUSH BUTTON START) Ref. to the appropriate SYSTEM WIRING diagram article. ENGINE TYPE FA (WITH PUSH BUTTON START).

Fig 1: O2 Sensor Signal Biased/Stuck Lean - Wiring Diagram (Bank 1 Sensor 2)
Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK REAR OXYGEN SENSOR CONNECTOR.	Has water entered the connector?	Completely remove any water inside.	Go to step 2.
2 CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR. Turn the ignition switch to OFF. Disconnect the connector from ECM and rear oxygen sensor. Measure the resistance of harness between ECM connector and rear oxygen sensor connector. Connector & terminal (E158) No. 42 - (E25) No. 3: (E158) No. 16 - (E25) No. 4:	Is the resistance less than 1 Ω?	Go to step 3.	Repair the open circuit of harness between ECM connector and rear oxygen sensor connector.
3 CHECK HARNESS BETWEEN ECM AND REAR OXYGEN SENSOR CONNECTOR. Connect the connector to ECM. Turn the ignition switch to ON. Measure the voltage between rear oxygen sensor connector and engine ground. Connector & terminal (E25) No. 3 (+) - Engine ground (-):	Is the voltage 2 V or more?	Go to step 4.	Replace the ECM. Ref. to ENGINE CONTROL MODULE (ECM) .
4 CHECK EXHAUST SYSTEM. Check exhaust system parts. NOTE: Check the following items. Looseness and improper fitting of exhaust system parts Damage (crack, hole etc.) of parts Damage (crack, hole etc.) between front oxygen (A/F) sensor and rear oxygen sensor	Is there any fault in exhaust system?	Repair or replace faulty parts.	Replace the rear oxygen sensor. < Ref. to REAR OXYGEN SENSOR . >