Center Differential Carrier: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the thrust bearing onto intermediate shaft.
Insert the intermediate shaft into the center differential assembly.
Install the pinion gears and washers.
Insert the pinion shaft into the center differential assembly.
NOTE:
- Insert the pinion shaft with the side with the plug side facing the front side (gear side).
- After inserting the pinion shaft, adjust its position so that the cutout portion on the front side is on the inner side.
Fig 1: Identifying Cutout Portion On Front Side (Gear Side) And Rear Side (Clutch Side)
Courtesy of SUBARU OF AMERICA, INC.
Install the snap ring.