FixVault
Home › Subaru › 2016 › WRX Limited, Automatic CVT Trans › Repair and Diagnosis › Transmission › Automatic Trans › Continuously Variable Transaxle (CVT) › Reduction Driven Gear › Removal

Reduction Driven Gear: Removal

  1. Remove the transmission from the vehicle. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Remove the extension case. < Ref. to REMOVAL , Extension Case. >
  3. Remove the rear drive shaft. < Ref. to REMOVAL , Rear Drive Shaft. >
  4. Remove the transfer clutch assembly. < Ref. to REMOVAL , Transfer Clutch. >
  5. Remove the center differential carrier. < Ref. to REMOVAL , Center Differential Carrier. >
  6. Remove the transfer reduction driven gear assembly. < Ref. to REMOVAL , Transfer Reduction Driven Gear. >
  7. Remove the intermediate case. < Ref. to REMOVAL , Intermediate Case. >
  8. Remove the forward clutch assembly. < Ref. to REMOVAL , Forward Clutch Assembly. >
  9. Remove the snap ring.
    Fig 1: Identifying Snap Ring
    G06654605Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the reduction driven gear assembly.
    Fig 2: Identifying Reduction Driven Gear Assembly
    G06654606Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the straight pin.
    Fig 3: Locating Straight Pin
    G06654607Courtesy of SUBARU OF AMERICA, INC.
About FixVault