Differential Case Assembly

1. Remove the twelve bolts and remove hypoid driven gear.
   Fig 1: Hypoid Driven Gear With Bolt

   Courtesy of SUBARU OF AMERICA, INC.
2. Drive out the straight pin from differential assembly toward hypoid driven gear side.

   ST 899904100 STRAIGHT PIN REMOVER

   Fig 2: Driving Out Straight Pin From Differential Assembly

   Courtesy of SUBARU OF AMERICA, INC.
3. Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.
   Fig 3: Pinion Shaft, Differential Bevel Pinion, Differential Bevel Gear And Adjusting Washer

   Courtesy of SUBARU OF AMERICA, INC.
4. Using the ST, remove the taper roller bearing.

ST 899524100 PULLER SET

Fig 4: Removing Taper Roller Bearing Using Puller Set (899524100)

Courtesy of SUBARU OF AMERICA, INC.