Main Shaft Assembly: Installation
- Attach the needle bearing and oil seal to the front of the main shaft assembly.
NOTE:
- Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.
- Apply NICHIMOLY N-130 or the equivalent to the sealing lip of the oil seal.
- Use a new oil seal.
- Fit the knock pin hole of the needle bearing outer race to the transmission case knock pin, and install the main shaft assembly.
NOTE:
- Align the end face of the seal with surface (A) when installing the oil seal.
Courtesy of SUBARU OF AMERICA, INC.
- Face the cutout portion of the snap ring for the ball bearing to the drive pinion shaft assembly.
Courtesy of SUBARU OF AMERICA, INC.
- Install the drive pinion shaft assembly. Ref. to
INSTALLATION , Drive Pinion Shaft Assembly.
- Check each shifter fork. Ref. to
INSPECTION , Shifter Fork and Rod.
- Select a main shaft rear plate. Ref. to
ADJUSTMENT , Main Shaft Assembly.
- Install the transmission case. Ref. to
INSTALLATION , Transmission Case.
- Install the transfer case together with the extension case assembly. Ref. to
INSTALLATION , Transfer Case and Extension Case Assembly.
- Install the manual transmission assembly to the vehicle. Ref. to
INSTALLATION , Manual Transmission Assembly.