Yaw Rate and G Sensor: Installation
CAUTION:
After completion of installation, set the following two positions.
- Positioning to the center of steering angle sensor
- Positioning the yaw rate & G sensors to zero
The above procedure is required for the VDCCM&H/U to identify the vehicle position afterward. For the setting procedures of the 2 steps above, refer to "Adjustment" in "VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)>ADJUSTMENT .
- Install each part in the reverse order of removal.
Tightening torque:
Yaw rate & G sensor: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
Console box assembly: 6.5 N.m (0.66 kgf-m, 4.8 ft-lb)
- Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .