FixVault
Home › Subaru › 2017 › Impreza Base, 4D Sedan, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 180 (Lighting System) › Auto Headlight Beam Leveler Control Module › Removal

Auto Headlight Beam Leveler Control Module: Removal

WARNING: This page is about a different car, the 2017 Subaru Outback and 2017 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
  2. Remove the cover assembly - instrument panel LWR driver. <Ref. to REMOVAL , Instrument Panel Lower Cover.>
  3. Remove the bolts, and then remove the panel - knee guard.
    Fig 1: Locating Panel - Knee Guard Bolts
    G10272470Courtesy of SUBARU OF AMERICA, INC.
  4. Release the lock and remove the relay holder.
    Fig 2: Relay Holder And Lock
    G10277273Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the auto headlight beam leveler Control Module.
    1. Remove the nut.
    2. Disconnect the connector and remove the auto headlight beam leveler Control Module.
Fig 3: Locating Auto Headlight Beam Leveler Control Module Nut And Connector
G10277274Courtesy of SUBARU OF AMERICA, INC.
About FixVault