Light Control Sensor: Removal

WARNING: This page is about a different car, the 2017 Subaru Outback and 2017 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Remove the trim panel - front pillar UPR. <Ref. to REMOVAL , Upper Inner Trim.>
Release the clips and claws, then detach the grille speaker side. <Ref. to TWEETER , REMOVAL, Front Speaker.>
Remove the sensor - automatic light.
1. Release the claws of the grille - front defroster.
  CAUTION:
  - Secure minimum space for performing the operation. Do not remove the grille - front defroster. If the grille - front defroster is removed, it cannot be reinstalled unless the instrument panel is removed.
  - Be careful not to damage the sensor and interior trim.
  Fig 1: Claws Of Grille - Front Defroster
  Courtesy of SUBARU OF AMERICA, INC.
2. Release the claws, and then pull out the sensor - automatic light from the grille - front defroster.
3. Disconnect the connector and remove the sensor - automatic light.
Fig 2: Removing Sensor - Automatic Light With Connector
Courtesy of SUBARU OF AMERICA, INC.